Standard Swaat Cass Cyclic Salt Spray Chamber Labo134SCS

LABONICS Labo134SCS Salt Spray Chambers are specific in their functions hence help out to carry out the process in a very rapid time. Quite easy to handle also. The SWAAT stands for Sea Water Acetic Acid Test. It is corrosion test where instead of Traditional Sodium Chloride, synthetic sea salt is used. The Solution is to be acidified with Glacial Acetic Acid and has to be performed under wet bottom conditions. This test can be used to determine time to perforation primarily on aluminum alloy brazing sheet used to manufacture heat exchangers or other parts. It can also applicable to determine how varying heat treatment parameters affect corrosion behavior. Apart from that testing of organic coatings on metal substrates can also be conducted, where by using low temperature one can prevent paint blistering

Get Quote Generate Catalog

Internal dimensions 800*1900*850(mm)
Overall dimensions 1350*3000*1700(mm)
Temperature range 10°C ~110°C
Humidity range 30% ~ 98% RH
Temperature Tolerance +/- 2.0 °C
Humidity Tolerance +2%,-3%
Salt concentration tolerance ±1%
Spray deposition 1~2ml / 80cm2 · h
Temperature sensor Platinum resistance. PT100ohm / MV A-class
Salt Water Pre heating The temperature for salt water should be equal with workroom temperature
Standard configuration Round bar / 1 piece; Sample holder / 1 piece; Spray nozzle / 2 pieces; Fog collectors / 2 pieces; Metering cylinder / 2 pieces
Safety device Humidifier dry-combustion protection, independent over-temperature protection, water shortage protection, over-current protection, refrigerant high-pressure protection switch, over-current circuit Breaker, earth leakage protection and so on.
Power Supply 380V 50HZ Three-phase five little system

  • Programmable color display touch screen controller Interface R232, Pc-link for Temperature Control
  • The Loading Method is Dynamic and is done mechanically
  • Provide with Digital Display Controlling
  • Can be handled manually also
  • Salt Fog is Collected with Funnel and Metering Cylinder
  • A dry and wet bulb sensor for Humidity
  • For the filtration of Salt Water supplied with Suction Tubes
  • Crystallization doesn’t occur in the Spraying System
  • Atomizer Tower for adequate Spraying into the chamber
  • The Exterior and Interior Material is of Glass fiber reinforced plastics
  • The chambers are not Anti-Aging and are Corrosion Resistant also
  • Provided with Spray Nozzle, Fog Collector and Metering Cylinder
  • Hydrostatic hood seal makes sure it’s completely sealed
  • A Three Phase five little system of Power Supply

To determine Corrosion behavior of the metals Swaat Cass Cyclic Salt Spray Chamber are widely used in Paint Companies to prevent Blistering, Metal Industries and Industries of Steel Aluminum etc